GeoStudio 2012, July 2012 Release

GeoStudio 2012, July 2012 Release

version 8.0.7.6129

Download the latest release.

Below are the changes made to GeoStudio since the previous release.

All Products

• Bug fix: KeyIn Regions displays this error when typing in a list of points: "Point 0 does not exist."
• Bug fix: The Result Times window in Results view would not always show time steps from all previous analyses in a chain.

SLOPE/W

• Bug fix: In KeyIn Slip Surface Entry and Exit, and in KeyIn Slip Surface Grid and Radius, values entered in the 'x' and 'y' controls may be changed unexpectedly and/or may generate unnecessary error messages.
• Bug fix: In KeyIn Slip Surface Entry and Exit, the entry and exit ranges would not snap to the ground surface line as they should, resulting in invalid ranges.
• Bug fix: In KeyIn Slip Surface Limits, the coordinate edit boxes would be disabled until "Specified Points" was cleared and re-checked.
• Bug fix: The Draw Factor of Safety Contours command was not computing the factor of safety properly at each grid point, resulting in invalid contours.
• Bug fix: Factor of safety contours would not display when the contour range was very large.
• Bug fix: In Results view, the Draw Contours command did not display any contours.
• Bug fix: Draw Probability did not display the P (Failure) plots for probabilistic analyses with multiple time steps.
• Bug fix: When opening a file created by earlier versions, probabilistic and sensitivity data would be lost.
• Bug fix: When opening a file created by earlier versions, Phi, Cohesion and Unit Weight would not be imported.

SEEP/W

• Bug fix: If an initial water table ended with a vertical line segment, the water table elevation to the right of the last segment was incorrect.

SIGMA/W

• Bug fix: When opening a file created by earlier versions, Unit Weight would not be imported.
• Bug fix: If an initial water table ended with a vertical line segment, the water table elevation to the right of the last segment was incorrect.

QUAKE/W

• Bug fix: When opening a file created by earlier versions, Unit Weight would not be imported.

CTRAN/W

• Change: Localization improvements were made in View Particle Tracking and View Particle Mass.